Toyota Corolla (E120): Precaution

  • Care must be taken to replace each part properly, because it could affect the performance of the brake system and result in a driving hazard. Replace the parts with the parts which have the same part number or equivalent.
  • It is very important to keep parts and the area clean when repairing the brake system.
  • If the vehicle is equipped with a mobile communication system, refer to the precaution in the introduction section.
    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the instrument panel ...

    Follow the correction procedures. (vehicles with a smart key system and with a drive monitor display)
    After taking the specified steps to correct the suspected problem, check that the warning light turns off. ■SRS warning light This warning light system monitors the airbag sensor assembly, front impact sensors, side impact sensors (front door), side impact sensors (front), side impac ...

    Transmission valve body assy (atm)
    Replacement 1. Remove engine under cover lh 2. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove automatic transaxle oil pan sub–assy Remove the 18 ...