Toyota Corolla (E170): Installation with LATCH system

1 Widen the gap between the seat cushion and seatback slightly.

► Type A

2 Latch the hooks of the lower straps onto the LATCH anchors. If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor.

For owners in Canada: The symbol on a child restraint system indicates the presence of a lower connector system.

► Type B

► Type B

2 Latch the buckles onto the LATCH anchors. If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor.

For owners in Canada: The symbol on a child restraint system indicates the presence of a lower connector system.

Installing child restraints using a seat belt

    Share this page:

    Other materials:

    Drive shaft / propeller shaft
    Preparation Sst Recomended tools Equipment Lubricant ...

    Precaution
    1. Handling precautions on srs airbag system The vehicle is equipped with srs (supplemental restraint system) such as the driver airbag and front passenger airbag. Failure to carry out service operation in correct sequence could cause the srs to unexpectedly deploy during servicing, po ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...