Toyota Corolla (E120): Inspection procedure
1 Check door lock
2 Check wire harness (tvip ecu door lock)
- Disconnect the tvip ecu and door lock connectors.
- check the continuity between the terminals of the tvip ecu and door lock connectors, as shown in the illustration and table.
Standard:
3 Check wire harness (door lock body ground)
- Disconnect the door lock connector.
- check the continuity between the terminal of the door lock connector and the body ground, as shown in the illustration and table.
Standard:
Proceed to next circuit inspection shown on problem symptoms table
Other materials:
Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat
outer belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...
General maintenance
Listed below are the general
maintenance items that
should be performed at the
intervals specified in the
"Owner's Warranty Information
Booklet" or "Owner's
Manual Supplement/Scheduled
Maintenance Guide". It
is recommended that any
problem you notice should
be brought to the attention
of your Toyota ...
Starting system
Inspection
1. Inspect starter assy
Notice:
these tests must be performed within 3 to 5 seconds to
prevent burnout of the coil.
perform the pull–in test.
Remove the nut, then disconnect the lead wire from
terminal c.
Connect the battery to the starter repai ...