Toyota Corolla (E120): Inner rear view mirror assy

Share this page:

Other materials:

Inspection procedure
1 Inspect transmission wire(s1) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

Pre–check
1. Selecting compass display mode  the compass switch allows you to select the display or non–display mode of the compass. 2. Setting zone  deviation between the ”magnetic north” and ”actual north” differs depending on the location. Therefore, adjustment of the ...

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...