Toyota Corolla (E120): Replacement
Hint
: installation is according to the reverse order of the removal.
1. Remove inner rear view mirror assy
- Remove the screw.
- w/ map lamp: disconnect the connector
- remove the rear view inner mirror assembly.
Other materials:
Overhaul
1. Inspect 1st gear thrust clearance
Using a feeler gauge, measure the 1st gear thrust clearance.
Standard clearance:
0.10 – 0.40 Mm (0.0039 – 0.0157 In.)
2. Inspect 2nd gear thrust clearance
Using a dial indicator, measure the 2nd gear thrust clearance.
Standard clearan ...
On–vehicle inspection
1. Inspect drive belt
Visually check the belt for excessive wear, frayed cords,
etc.
If any defect is found, replace the drive belt.
Hint:
cracks on the rib side of a belt are considered acceptable. If the
missing chunks from the ribs are found on the belt, it should be
replaced.
2 ...
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove luggage compartment door cover
2. Remove rear spoiler
remove the 2 screws.
disconnect the wire harness connector.
put protective tape.
&nb ...