Toyota Tacoma manuals

Toyota Corolla Repair Manual: Hazard warning switch circuit

Light control switch circuit
Wiring diagram Inspection procedure 1 Check headlamp dimmer switch assy (light control switch) 2 Check wire harness (tvip ecu  light control switch) Disconnect the tvip ecu and ...

Circuit description
When the tvip system is transferred to the alarm sounding state from the armed state, the signal flasher assembly (relay for hazard warning lights) will be switched on and the hazard warning ligh ...

Other materials:

Inspection procedure
Hint: read freeze frame data using the handheld tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the ...

Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...

Circuit description
The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0135/73 is recorded when a short is detected in the p/t squib (lh) circuit. Wiring diagram ...

2011-2019 Copyright www.tcorolla.net