Toyota Corolla (E120): Floor shift shift lever assy

Share this page:

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Circuit description
In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...

Overhaul
Notice: when installing, coat the parts indicated by the arrow with power steering fluid or molybdenum disulfide lithium base grease. 1. Precaution 2. Disconnect battery negative terminal 3. Inspect center front wheel 4. Remove horn button assy 5. Remove steering wheel assy sst 09950–50013 ...