Toyota Corolla (E120): Door courtesy switch circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Rear combination lamp assy lh
Replacement Using a clipremover, remove the 2 clips and disconnect the luggage compartment trim cover lh. Disconnect the connector and remove the 3 nuts. Pull out the rear combination light assy lh to the back of the vehicle, and remove. ...

Lubrication system
On–vehicle inspection 1. Check engine oil level  after warming up the engine and then 5 minutes after the engine stops, oil level should be between the ”l” and ”f” marks on the oil level gage. If low, check for leakage and add oil up to the ”f” mark. Notice: do not ...