Toyota Corolla (E170): Correct use of the seat belts

● Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder.

● Position the lap belt as low as possible over the hips.

● Adjust the position of the seatback.

Sit up straight and well back in the seat.

● Do not twist the seat belt.

Fastening and releasing the seat belt

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect shift solenoid valve(s1) Remove the shift solenoid valve s1. measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...