Toyota Corolla (E120): Components

Replacement

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Foamed material application areas
    If an increase in temperature or other condition damages the foamed material when repairing or replacing the panel, fill in the insufficient areas with urethane foam. The following illustration shows the areas for one side, but the foamed material must be applied equally to both the left and r ...

    Inspection procedure
    Hint: this dtc chart is on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table on page 05–42. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions ...