Toyota Corolla (E120): Components

Overhaul

    Share this page:

    Other materials:

    Turning on the high beam headlights
    1 With the headlights on, push the lever away from you to turn on the high beams. Pull the lever toward you to the center position to turn the high beams off. 2 Pull the lever toward you and release it to flash the high beams once. You can flash the high beams with the headlights on or off. &# ...

    Out side moulding
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove outside moulding Put protective tape around the moulding.  insert a piano wire between the vehicle body and moulding.  tie objects that can serve as handles (for example, wooden blocks) to all ...

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...