Toyota Corolla (E120): Cylinder head assy

Share this page:

Other materials:

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

Rear axle lh hub bolt
Replacement Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Remove rear axle lh hub bolt Using sst and a hammer handle or an equivalent, remove the lh hub bolt. Sst 09628–10011 4. Install rear axle lh hub bolt Install a washer and nut to a ...

Pre–check
1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...