Toyota Corolla (E120) 2002–2008 Repair Manual / Clutch / Clutch release cylinder assy (mtm)

Toyota Corolla (E120): Clutch release cylinder assy (mtm)

Share this page:

Other materials:

Inspection procedure
1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...