Toyota Corolla (E120): Circuit description

The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b1187/55 is recorded when ground short is detected in the p squib (2nd step) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Checking and adding the brake fluid
    ■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using hand–held tester. 1 Inspect brake actuator assy Select the datalist mode on the hand–held tester.  check the operation sound of the abs pump motor when operat ...

    Malfunction in water temperature receiver gauge
    Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...