Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Open in d squib (2nd step) circuit / Circuit description
Toyota Corolla (E120): Circuit description
Circuit description
Wiring diagram
Other materials:
Check open circuit
For the open circuit in the wire harness in fig. 1, Perform
a resistance check in step (b) or a voltage check in step
(c) to locate the section.
Check the resistance.
Disconnect connectors a and c and measure the
resistance between them.
Resistance: 1 Ω or les ...
RCTA (Rear Cross Traffic Alert)
function
The RCTA function uses the
BSM rear side radar sensors
installed behind the rear
bumper. This function is
intended to assist the driver
in checking areas that are
not easily visible when
backing up.
WARNING
■Cautions regarding the use of
the system
The driver is solely responsible for
safe driving ...
For vehicles equipped with catalytic converter
Caution:
if large amount of unburned fuel flows into the converter, it may cause
overheating and a fire hazard.
To prevent this, observe the following precautions.
Use only unleaded gasoline.
avoid prolonged idling.
Avoid running the engine at idle speed for more than 20 minutes. ...