Toyota Tacoma manuals

Toyota Corolla Repair Manual: Circuit description

The seat belt buckle switch (lh) circuit consists of the airbag sensor assy center and front seat inner belt assy (lh).

Dtc b0126/b0127/27 is recorded when a malfunction is detected in the seat belt buckle switch (lh) circuit.

Wiring diagram

Wiring diagram

Inspection procedure

Seat belt buckle switch (lh) malfunction
Dtc b0126/27 seat belt buckle switch (lh) malfunction Dtc b0127/27 seat belt buckle switch (lh) malfunction ...

Inspection procedure
1 Check wire harness(airbag sensor assy center front seat inner belt assy lh) Disconnect the negative () terminal cable from the battery, and wait at least for 90 seconds.  discon ...

Other materials:

Front door belt moulding assy lh
Replacement Hint: the installation procedures are the removal procedures in reverse order. Use the same procedures for the rh side and lh side. 1. Remove front armrest assy lh 2. Remove power window regulator master switch assy (w/ power window) 3. Remove front armrest base panel up ...

Electronic control
Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative () terminal cable beforehand so as to prevent burntout damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch and li ...

Onvehicle inspection
1. Inspect airfuel ratio compensation system Hint: you can also check the system by choosing data monitor, then o2 sensor output voltage on the monitor of the handheld tester. Connect the handheld tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of the ecm. Cau ...

2011-2019 Copyright www.tcorolla.net