Toyota Corolla (E120): Circuit description

The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0112/41 is recorded when ground short is detected in the side squib (rh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

    Evap monitor (vacuum pressure monitor)
    Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

    Abbreviations used in this manual
    ...