Toyota Corolla (E120): Circuit description

The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0111/44 is recorded when an open is detected in the side squib (rh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Overhaul
    1. Precaution 2. Disconnect battery negative terminal 3. Inspect place front wheels facing straight ahead 4. Remove horn button assy Notice: if the airbag connector is disconnected with the ignition switch being at on, dtcs will be recorded.  using a torx socket wrench, loosen the ...

    Overhaul
    Notice: when using a vise, do not over tighten. When installing, coat the parts indicated by the arrows with power steering fluid . 1. Remove front wheel rh 2. Drain power steering fluid 3. Remove engine under cover rh 4. Remove fan and generator v belt 5. Disconnect oil reservoir to ...

    Inside rear view mirror
    The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view. Adjusting the height of rear view mirror The height of the rear view mirror can be adjusted to suit your driving posture. Adjust the height of the rear view mirror by moving it up and down. WARNING ...