Toyota Corolla (E120): Circuit description

Refer to dtc c0200/31, c0205/32, c1235/35, c1236/36

Hint:

Hint

: Dtc no. C0210/33, c1238/38 is for the right rear speed sensor.

Dtc no. C0215/34, c1239/39 is for the left rear speed sensor. Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Overhaul
    1. Precaution 2. Disconnect battery negative terminal 3. Inspect place front wheels facing straight ahead 4. Remove horn button assy Notice: if the airbag connector is disconnected with the ignition switch being at on, dtcs will be recorded.  using a torx socket wrench, loosen the ...

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

    On–vehicle inspection
    1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...