Toyota Corolla (E120) 2002–2008 Repair Manual / Exterior/interior trim / Body rocker panel moulding lh
Toyota Corolla (E120): Body rocker panel moulding lh
Replacement
Hint
: use the same procedures for the rh side and lh side.
1. Remove body rocker panel moulding lh

- Remove the 8 retainers.
- using a screwdriver, remove the moulding.
Hint
: tape the screwdriver tip before use.
- remove the 7 clips from the moulding.
2. Install body rocker panel moulding lh

- Install the moulding with 7 new clips.
- install the 8 retainer to the moulding.
Other materials:
USB charging port (if
equipped)
The USB charging port are used
to supply 3.0 A of electricity at 5
V to external devices.
The USB charging port are for
charging only. They are not
designed for data transfer or
other purposes.
Depending on the external
device, it may not charge properly.
Refer to the manual
included with the dev ...
Inspection procedure
Hint:
read freeze frame data using the hand-held tester or the obd ii scan tool.
Freeze frame data records the
engine conditions when a malfunction is detected. When troubleshooting, it is
useful for determining whether
the vehicle was running or stopped, the engine was warmed up or not, the ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Perform active test by hand–held tester(abs motor relay)
Check the operation sound of the abs motor individually when operaing it
with the ...


