Toyota Corolla (E120): Side mudguard sub–assy lh

Replacement

Hint

: use the same procedures for the rh side and lh side.

1. Remove side mudguard sub–assy lh

  1. Using a clip remover, remove the 8 retainers and 9 clips.
  2.  using a moulding remover, remove the mudguard.

2. Install side mudguard sub–assy lh

  1. Install the mudguard with 9 new clips.
  2.  install the 8 retainers to the mudguard.
    Share this page:

    Other materials:

    On–vehicle inspection
    1. Inspection throttle body idle speed control valve assy Notice: it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal. After check ...

    Source voltage drop
    The srs is equipped with a voltage–increase circuit (dc–dc converter) in the airbag sensor assy center in case the source voltage drops. When the battery voltage drops, the voltage–increase circuit (dc–dc converter) functions to increase the voltage of the srs to normal voltage. ...

    Adjustment
    Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect front door panel sub–assy lh Che ...