Toyota Corolla (E120): Initialization

1. Reset memory

Caution

: perform the reset memory (at initialization) when replacing the automatic transaxle assy, engine assy or ecm.

Notice

: hand–held tester only

  1. Turn the ignition switch off.
  2.  connect the hand–held tester to the dlc3.
  3.  turn the ignition switch to the on position.
  4.  perform the reset memory procedure from the engine menu.

Caution

: after performing the reset memory, be sure to perform the road test described earlier.

Diagnostic trouble code chart

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect transmission wire(slt) Disconnect the transmission wire connector from the transaxle. measure the resistance according to the value(s) in the table below. Standard: Measure the resistance according to the value(s) in the table below. Standard (check for short): ...

    If a warning light turns on or a warning buzzer sounds
    Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system. However, if this continues to occur, have the vehicle inspected by your Toyota dealer. Actions to ...

    Circuit description
    The vapor pressure sensor, vsv for canister closed valve (ccv), vsv for pressure switching valve are used to detect abnormalities in the evaporative emission control system. The ecm decides whether there is an abnormality in the evaporative emission control system based on the vapor pressur ...