Toyota Corolla (E120): Engine mechanical

Preparation

Sst

Recomended tools

Recomended tools

Ssm

Ssm

Equipment

Equipment

Exhaust

Exhaust

Preparation

Equipment

Cooling

    Share this page:

    Other materials:

    Inspection procedure
    1 Reconfirm dtc Check the dtc 2 Inspect skid control ecu connector securely connected 3 Inspect skid control ecu connector(ig1 terminal voltage) In case of using hand–held tester:  check the voltage condition output from the ecu displayed on the hand–held tester. O ...

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds. disconnect the connectors between the airbag sensor assy center and the horn button assy. release the airbag activ ...

    Inspection procedure
    1 Check ignition or starter switch assy Check the ignition switch, as shown in the illustration and table. Standard: 2 Check fuse (ecu–b) Remove the fuse from the instrument panel j/b.  check the continuity of the fuse. Standard: continuity 3 Check relay (m ...