Toyota Corolla (E170): Using the steering wheel switches to change audio source

The audio source changes as follows each time the “MODE/HOLD” switch is pressed.

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

    Rear combination lamp assy lh
    Replacement Using a clipremover, remove the 2 clips and disconnect the luggage compartment trim cover lh. Disconnect the connector and remove the 3 nuts. Pull out the rear combination light assy lh to the back of the vehicle, and remove. ...

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...