Toyota Corolla (E170): Using Bluetooth® devices

Share this page:

Other materials:

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...

Pre–check
1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...