Toyota Tacoma manuals

Toyota Corolla Owners Manual: Status display

You can check indicators such as signal strength and battery charge on the phone screen.

1Connection status
2 Signal strength
3 Battery charge

Making a call

Phone screen
To display the screen shown below, press the switch on the steering wheel or the button. Several functions are available to operate on each screen that is displayed by selecting the 4 tabs. 1 ...

Making a call
Once a Bluetooth phone is registered, you can make a call using the following procedure: ...

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pullin test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repair ...

How to proceed with troubleshooting
1 Vehicle brought to workshop 2 Customer problem analysis 3 Problem symptom confirmation 4 Circuit inspection 5 Repair or replace 6 Confirmation test 7 End Customer problem analysis check ...

2011-2018 Copyright www.tcorolla.net