Toyota Corolla (E120): Sfi system

Share this page:

Other materials:

Electronic control
Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs motor relay) Check the operation sound of the abs motor individually when operaing it with the ...

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...