Toyota Corolla (E170) 2014–2019 Owners Manual / Interior features / “SET UP” menu / Using the “SET UP” menu (“Bluetooth” menu) / Setting automatic connection of the device on or off
Toyota Corolla (E170): Setting automatic connection of the device on or off
If “BT power” is set to on, the registered device will be connected automatically when the engine switch is turned to the “ACC” position (vehicles without a smart key system) or ACCESSORY mode (vehicles with a smart key system).
1 Select “BT Power” using
.
2 Select “ON” or “OFF” using
.
Other materials:
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt or snow:
1 Stop the engine. Set the parking brake and shift the shift lever to P (automatic
transmission or continuously variable transmission) or N (manual transmission).
2 Remove the mud, snow or s ...
Terminals of ecu
1. Inspect tvip ecu
Inspect the ecu–b, dome and ecu–ig fuses.
disconnect the tvip ecu connector, and the continuity and voltage of
check each terminal of the disconnected
connector.
Standard:
If the result is not as specified, the vehicle’s side may malfunction.
Reco ...
Circuit description
When the ignition switch is turned on, battery positive voltage is applied to
the coilwhich closes the contacts
of the efi main relay (marked: efi) and supplies power to terminal +b of the ecm.
This signal causes current to flow to the coil, closing the contacts of the efi
relay and supplyin ...


