Toyota Corolla (E170): Displaying the device status

Select “Bluetooth* info” using .

● Displaying the device name Select “Device Name” using ● Displaying the device address.

● Displaying the device address Select “Device Address” using *: Bluetooth is a registered trademark of Bluetooth SIG, Inc..

*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.

    Share this page:

    Other materials:

    Circuit description
    The variable valve timing (vvt) system includes the ecm, the oil control valve (ocv) and the vvt controller. The ecm sends a target ”duty–cycle” control signal to the ocv. This control signal, applied to the ocv, regulates the oil pressure supplied to the vvt controller. Camshaft timin ...

    Circuit description
    The vehicle speed sensor circuit is sent to cruise control ecu assy as a vehicle speed signal. For each rotation of the shaft, the vehicle speed sensor sends a signal through the combination meter assembly to the cruise control ecu assy (see the following chart). The cruise control ecu assy ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...