Toyota Corolla (E170): Replying to a message

1 Display the “Message Inbox” screen. 2 Select the desired message from the list.

3 Select “Quick Message”.

4 Select the desired message.

5 Select “Send”.

■ Editing quick reply message

1 Select “Quick Message”.

2 Select message to edit. corresponding to the desired message to edit.

3 Select “OK” when editing is completed.

    Share this page:

    Other materials:

    Skid control sensor
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

    Starting system
    Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

    Installing the spare tire
    1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...