Toyota Corolla (E170): Calling the message sender

Calls can be made to an e-mail/SMS/MMS message sender's phone number.

1 Display the “Message Inbox” screen. 2 Select the desired message.

3 Select 4 Check that the “Call” screen is displayed..

4 Check that the “Call” screen is displayed.

■ Calling from a number within a message

Calls can be made to a number identified in a message's text area.

1 Display the “Message Inbox” screen. 2 Select the desired message.

3 Select the text area.

4 Select number. corresponding to the desired number.

5 Check that the “Call” screen is displayed.

■ Calling from the incoming message screen

    Share this page:

    Other materials:

    How to proceed with troubleshooting
    1 Vehicle brought to workshop 2 Customer problem analysis 3 Check and clear dtc 4 Problem symptom confirmation Symptom does not occur (go to step 5) 5 Symptom simulation 6 Dtc check 7 Dtc chart 8 Problem symptoms table 9 Circuit inspection 10 Confirmation test End ...

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...