Toyota Corolla (E120): Repair

Hint

: this is a flow chart for vehicle pull.

Front suspension

    Share this page:

    Other materials:

    Overhaul
    1. Drain clutch fluid 2. Remove brake master cylinder sub–assy 3. Remove brake booster assy 4. Disconnect clutch reservoir tube Loosen the clip and disconnect the clutch reservoir tube from the clutch master cylinder assy. Hint: use a container to catch the fluid. 5. Disconnect ...

    Inspection procedure
    1 Inspect ecm(+b voltage) Turn the ignition switch on.  measure the voltage between the terminals of the e4 and e6 ecm connectors. Standard: 2 Check harness and connector(ecm – body ground) Disconnect the e4 ecm connector. check the resistance between the wire ...

    On–vehicle inspection
    1. Horn button assy (vehicles not involved in collision) Check the diagnostic system . visually check the following item with the horn button assy (with airbag) installed in the vehicle. Check cuts, minute cracks or marked discoloration on the horn button assy top surface and in the ...