Toyota Corolla (E170) 2014–2019 Owners Manual / For safety and security / For safe use / Installing child restraints / Removing a child restraint installed with a seat belt
Toyota Corolla (E170): Removing a child restraint installed with a seat belt
Push the buckle release button and fully retract the seat belt.
Other materials:
Starting system
Inspection
1. Inspect starter assy
Notice:
these tests must be performed within 3 to 5 seconds to
prevent burnout of the coil.
perform the pull–in test.
Remove the nut, then disconnect the lead wire from
terminal c.
Connect the battery to the starter repai ...
Circuit description
The side squib (rh) circuit consists of the airbag sensor assy center and
front seat airbag assy (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0110/43 is recorded when a short is detected in the side squib (rh)
circuit.
Wiring diagram
...
Pressing power switch does not start system
Wiring diagram
Inspection procedure
1 Inspect radio receiver assy(+b, acc, gnd)
Check that the continuity between terminals at each
condition, as shown in the chart.
Standard:
Check that the voltage between terminals at each condition,
as shown in the chart.
Standard:
...