Toyota Corolla (E170): Registering a new contact to the contact list

New contact data can be registered. Up to 4 numbers per person can be registered. For PBAP compatible Bluetooth® phones, this function is available when “Automatic Contact/History Transfer” is set to off.

1 Select “New Contact”.

2 Enter the name and select “OK”.

3 Enter the phone number and select “OK”.

4 Select the phone type for the phone number.

5 To add another number to this contact, select “Yes”.

■ Registering a new contact in a different way (From the “Call History” screen)

1 Display the phone screen. 2 Select the “Call History” tab and select a contact not yet registered in the contact list.

3 Select “Add to Contacts”.

4 Follow the steps in “Registering a new contact to the contacts list” from “STEP 3”.

    Share this page:

    Other materials:

    Malfunction in fuel receiver gauge
    Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs motor relay) Check the operation sound of the abs motor individually when operaing it with the ...

    Problem symptoms table
    Hint: proceed with troubleshooting of each circuit in the table below. Symptom Suspect area When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.  Srs warning light ci ...