Toyota Corolla (E120): Rear bumper

Share this page:

Other materials:

Inspection procedure
1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...

License plate lamp assy
Replacement 1. Remove luggage compartment lock cylinder & key set 2. Remove luggage compartment door garnish outside 3. Remove license plate lamp assy Pull the license plate light assy to the side of vehicle as shown in the illustration and release the claw.  disconnect the c ...

Inspection procedure
1 Check door lock 2 Check wire harness (tvip ecu door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the tvip ecu and door lock connectors, as shown in the illustration and table. Standard: 3 Check wire harness ...