Toyota Corolla (E170): Random playback

Pressing playback mode in the following order: (RDM) changes the random playback mode in the following order:

Switching the display

    Share this page:

    Other materials:

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

    Pre–check
    1. Diagnosis check Starting diagnosis mode (service check mode)  turn off the audio system and turn the ig switch to acc. While pressing the preset switches ”1” and ”6” at the same time, press ”cd” 3 times. Reference: beep sound is given 3 times and the sys ...

    Skid control sensor
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...