Toyota Corolla (E120): Output shaft assy (c59)

Share this page:

Other materials:

Evap monitor (vacuum pressure monitor) (continued)
Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 ...

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

Circuit description
The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b1180/17 is recorded when a short is detected in the d squib circuit (2nd step). Wiring diagra ...