Toyota Corolla (E120): On–vehicle inspection

1. Connect hand–held tester:

  1.  connect the hand–held tester to the dlc3.
  2.  start the engine and run it at idle.
  3.  select the active test mode on the hand–held tester.

Hint

: please refer to the hand–held tester operator’s manual for further details.

2. Inspect actuator motor operation

  1.  with the motor relay on, check the actuator motor operation noise.
  2.  turn the motor relay to off.
  3. depress the brake pedal and hold it for about 15 seconds. Check that the brake pedal cannot be depressed.
  4.  with the motor relay on, check that the pedal does not pulsate.

Notice

: do not keep motor relay on for more than 5 seconds continuously. When operating it continuously, set the interval more than 20 seconds.

  1.  turn the motor relay to off and release the brake pedal.

3. Inspect right front wheel operation

Notice

: never turn on the solenoid which is not described below.

  1.  with the brake pedal depressed, perform the following operations.
  2.  turn the sfrh and sfrr solenoid to on simultaneously, and check that the pedal cannot be depressed.

    Notice

    : do not keep solenoid on for more than 10 seconds continuously. When operating it continuously, set the interval more than 20 seconds.

  3.  turn the sfrh and sfrr solenoid to off simultaneously, and check that the pedal can be depressed.
  4.  turn the motor relay to on, and check that the pedal returns.

    Notice

    : do not keep motor relay on for more than 5 seconds continuously. When operating it continuously, set the interval more than 20 seconds.

  5.  turn the motor relay to off and release the brake pedal.

4. Inspect other wheel operation

  1.  as the same procedure, check the solenoids of other wheels.

Hint

:

  • left front wheel: sflh, sflr
  • right rear wheel: srrh, srrr
  • left rear wheel: srlh, srlr
    Share this page:

    Other materials:

    Inspection
    1. Charcoal canister assy Visually check the charcoal canister for cracks or damage. Inspect the charcoal canister operation.  Plug the vent port with the cap.  While holding the purge port closed, blow air (1.76 Kpa, 18 gf/cm2, 0.26 Psi) into the evap port and ...

    Inspection procedure
    1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

    Evap monitor (vacuum pressure monitor)
    Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...