Toyota Corolla (E120): Manual transaxle assy (c59)

Share this page:

Other materials:

Inspection procedure
1 Inspect transmission wire(sl) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission wire c ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Auto connection
To turn auto connection mode on, set “Bluetooth* Power” to on. When you register a phone, auto connection will be activated. Always set it to this mode and leave the Bluetooth® phone in a place where a connection can be established. When the engine switch is turned to ACCESSORY or ON <IG ...