Toyota Corolla (E120): Manual transaxle assy

Share this page:

Other materials:

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

Replacement
1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove air cleaner cap sub–assy 3. Remove air cleaner case sub–assy  remove the air cleaner element, then remove the 3 bolts and air cleaner case sub–assy. ...

Inspection procedure
1 Inspect park/neutral position switch assy Disconnect the park/neutral position switch connector.  measure resistance according to the value(s) in the table below when the shift lever is moved to each position. Standard: 2 Check harness and connector(park/neutral position ...