Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d main switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check harness and connector(transmission control switch – body ground)
- Disconnect the transmission control switch connector of shift lever assy.
- measure the resistance according to the value(s) in the table below.
Standard:
2 Inspect transmission control switch
- Measure the resistance according to the value(s) in the table below.
Standard:
3 Check harness and connector(transmission control switch – ecm)
- Connect the transmission control switch connector of shift lever assy.
- disconnect the ecm connector.
- measure the resistance according to the value(s) in the table below.
Standard:
Proceed to next circuit inspection shown on problem symptoms table
Other materials:
Emergency towing
If a tow truck is not available in an emergency, your vehicle may be temporarily
towed using a cable or chain secured to the emergency towing eyelet. This should
only be attempted on hard surfaced roads for short distances at low speeds.
A driver must be in the vehicle to steer and operate the ...
Precaution
Caution:
replace the faulty parts of the seat belt systems (outer belt, inner belt,
bolts, nuts, adjustable shoulder
anchor, tether anchor hardware, sill–bar, etc.).
Seat belt systems not in use at the time of a collision should also be inspected
and replaced if found
to be damaged or wo ...
If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle
in the normal way, stop the vehicle using the following procedure:
1 Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required ...