Toyota Corolla (E120): Inspection

1. Inspect water pump assy

  1. Visually check the drain hole for coolant leakage.
    Share this page:

    Other materials:

    BSM (Blind Spot Monitor)
    The Blind Spot Monitor is a system that uses rear side radar sensors installed on the inner side of the rear bumper on the left and right side to assist the driver in confirming safety when changing lanes. WARNING ■Cautions regarding the use of the system The driver is solely responsible for sa ...

    Engine (ignition) switch (vehicles without a smart key system)
    Starting the engine 1. Check that the parking brake is set. 2. Check that the shift lever is in P. 3. Firmly depress the brake pedal. 4. Turn the engine switch to START to start the engine. ■If the engine does not start The engine immobilizer system may not have been deactivated. Contact your Toy ...

    Thermostat
    Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...