Toyota Corolla (E120): Horn button assy

Share this page:

Other materials:

Inspection
1. Inspect sliding roof limit switch Inspect the sliding roof limit switch continuity. Standard: If the continuity is not as specified, replace the switch. 2. Inspect sliding roof drive gear sub–assy Connect the positive (+) lead from the battery to terminal 2 and the ne ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...