Toyota Corolla (E120): Components

Replacement

    Share this page:

    Other materials:

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Rear suspension
    Preparation Sst Recomended tools Equipment Tire & wheel Preparation Equipment ...

    Inspection
    1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...