Toyota Corolla (E120): Components

Removal & installation and disassembly & re

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

    Replacement
    Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire (w/ abs) 4. Remove rear axle hub & bearing assy lh Remove the 4 bolts and hub & bearing assy lh. 5. Install rear axle hub & bearing assy lh Install t ...

    Diagnostic trouble code chart
    Notice: when removing the part, turn the ignition switch to off. Hint: using sst 09843–18040, it connect the terminal tc and cg of dlc3. If any abnormality is not found when inspecting parts, inspect the ecu and ground points for poor contact. If a malfunction code is displayed during ...