Toyota Corolla (E120): Circuit description

The cruise control ecu assy power source supplies power to the actuator and sensors, etc., When terminal gnd and the case of the cruise control ecu assy are grounded.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    If the shift lever cannot be shifted from P (except vehicles with a manual transmission)
    If the shift lever cannot be shifted with your foot on the brake pedal, there may be a problem with the shift lock system (a system to prevent accidental operation of the shift lever). Have the vehicle inspected by your Toyota dealer immediately. The following steps may be used as an emergency ...

    Rear axle beam assy
    Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

    Starting system
    Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...