Toyota Corolla (E120): Circuit description

The circuit detects the rotation position of the actuator control plate and sends a signal to the cruise control ecu assy

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Eco Driving Indicator Light customization (except vehicles with a manual transmission)
    Eco Driving Indicator Light can be activated or deactivated. 1 While the odometer is being displayed, press and hold the “DISP” switch to display the Eco Driving Indicator Light customization screen. 2 Press the “DISP” switch to set Eco Driving Indicator Light to on or off. 3 Press and ...

    Inspection
    1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...

    On–vehicle inspection
    1. Inspect air–fuel ratio compensation system Hint: you can also check the system by choosing ”data monitor”, then ”o2 sensor output voltage” on the monitor of the hand–held tester. Connect the hand–held tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...