Toyota Corolla (E120): Circuit description

The door key lock and unlock switch is built in the door lock motor.

Wiring diagram

Inspection procedure

Inspection procedure

1 Check door lock

2 Check wire harness (tvip ecu  door lock)

2 Check wire harness (tvip ecu  door lock)

  1. Disconnect the tvip ecu and door lock connectors.
  2.  check the continuity between the terminals of the tvip ecu and door lock connectors, as shown in the illustration and table.

Standard:

3 Check wire harness (door lock  body ground)

3 Check wire harness (door lock  body ground)

  1. Disconnect the door lock connector.
  2.  check the continuity between the terminal of the door lock connector and the body ground, as shown in the illustration and table.

Standard:

Proceed to next circuit inspection shown on problem symptoms table

Proceed to next circuit inspection shown on problem symptoms table

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Inspect wireless door lock control functions Hint: the switch described in this text is a switch for transmitting signals (lock switch, unlock switch and panic switch) which is built into the door control transmitter. All the functions listed below must be checked in the remote contro ...

    Ecu power source circuit
    Circuit description This circuit provides power to operate the tvip ecu. Wiring diagram Inspection procedure 1 Check fuse (ecu–b) Remove the fuse from the instrument panel j/b.  check the continuity of the fuse. Standard: continuity 2 Check tvip ecu Disconnect ...

    Floor shift cable transmission control shift
    Replacement Hint: components: 1. Remove air conditioner unit assy Hint: refer to the instructions for removal of the air conditioner unit assy. 2. Separate air bag sensor assy center  remove the 3 bolts, separate the airbag sensor assy center. 3. Remove exhaust pipe assy 4. Remo ...