Toyota Corolla (E120): Circuit description

When the tvip system operates, the tvip ecu controls the starter cut relay so that the relay should not be turned on and consequently the starter can not crank the engine.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Heated steering wheel/seat heaters
    Heated steering wheel Warms up the grip of the steering wheel Seat heaters Warm up the seat upholstery WARNING To prevent minor burn injuries Care should be taken if anyone in the following categories comes in contact with the steering wheel or seats when the heater is on: Babies, small chil ...

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. 1 Turn the engine switch off. 2 Open the fuse box cover. ► Engine compartment Push the tab in and lift the lid off. ► Under the driver’s side i ...

    Circuit description
    The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b1180/17 is recorded when a short is detected in the d squib circuit (2nd step). Wiring diagra ...