Toyota Corolla (E170) 2014–2019 Owners Manual / For safety and security / For safe use / Seat belts / Adjusting the seat belt shoulder anchor height (front seats)

Toyota Corolla (E170): Adjusting the seat belt shoulder anchor height (front seats)

1 Push the seat belt shoulder anchor down while pressing the release button.

2 Push the seat belt shoulder anchor up.

Move the height adjuster up and down as needed until you hear a click.

Seat belt pretensioners (front seats)

    Share this page:

    Other materials:

    Inspection procedure
    1 Check front airbag sensor (rh) circuit (to b+)(airbag sensor assy center – airbag front rh sensor) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag front rh sensor and the airbag sen ...

    Inspection procedure
    1 Inspect park/neutral position switch assy Disconnect the park/neutral position switch connector.  measure resistance according to the value(s) in the table below when the shift lever is moved to each position. Standard: 2 Check harness and connector(park/neutral position ...

    Temporarily engaged gear steps selection mode in the D position
    To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...